Make sure that the second pressure on the dual watch key occurs within 23 seconds after the
first one, otherwise the DW function will be aborted, which will be indicated by the extinction
of the flashing dual watch symbol "
DW
" in the display.
13) Key lock function [ SC / KL ]
To acitivate the key lock function, press the key lock key ( 8 ) [
SC / KL
] and hold it until the
key lock symbol appears in the display .
All keys and selectors are blocked and only transmission is possible.
To deactivate the key lock function press the key lock key ( 8 ) [
SC / KL
] until the symbol
disappears in the display.
Now the keys are released again.
14) External speaker jack
The MX8 Mark-I is equipped with a 3.5 mm jack socket ( 17 ) at the rear p
anel to connect an
external speaker of 4 - 8 ohm impedance. At 4 ohms the speaker load can be 4 watts ( e.g. TEAM
TS-500 ). When the external speaker is connected, the internal speaker will be switched of f.
15) Signal meter internal/external
The bar meter in the LCD window shows in reception mode the signal strength of a received sig-
nal ( S value ), and in transmit mode the signal strength of the transmit signal. There is also a 2.5
mm jack socket ( 18 ) at the rear panel of the MX8 Mark-I to connect an external S-meter with a
2.5 mm plug. It can show the S values more exactly. Please note that the external S-meter shows
only the relative field strength of the incoming signal.
English
English
Additional information
1) Safety instruction
Drivers must keep attention about traf fic rules by using the transceiver in a vehicle. Drivers
should use an assembly for handsfree radio operation while driving, for example the VOX
function or a handsfree microphone set like TEAM DM-106VOX.
The unit radiates RF energy in transmit mode. Please keep an eye on safety dist ance to the
antenna.
2) General precautions
Protect the set from humidity and dust. Do not store at places where the temperature may
rise and cause damage, for example in the sun. The set can be cleaned by wiping with a soft
cloth. Do not use chemical products to clean the set.
3) Servicing
The device must not be opened. Independent rep airs or adjustment must not be carried out,
since each modification or unauthorised intervention will result in the cancelling of the oper-
ating permit and of the warranty and repair claims. Do not use the set if it seems not to func-
tion correctly. Disconnect the set in this case from the DC power source immediately. If there
is a defect, the authorised TEAM specialist dealer or TEAM must be contacted in every case.
4) Conformity
The CB mobile transceiver TEAM MX8 Mark-I complies to the European directive R&TTE and
meets the European st andards EN 300 135-2, EN 300 433-2, EN 301 489-1/-13 and EN
60950-1.
The specific regulations of the different versions in the different european countries can be found
in the radio passport that is included in this manual.
Specifications are subject to change without any prior notice or obligation on the p art of the manufacturer.
18
19
Additional Accessories
EBS-MX
DIN Mounting Kit including
screws and front cover
CB6602
mx-8mark1_manual.qxp 14.09.2009 16:45 Seite 18