Team Nisca L201-S, Руководство пользователя

Страница: 64 / 72

64
©2017 All rights reserved
-Remove Jammed Card
1. Turn the power off.
E31
Description
Error
Messages
Solution
E41
Please contact the service representative
promptly to avoid injuries.
(If this occurs when “Initializing”, do not
try more than twice.)
The Sensor does not recognize the mark
on the film When it starts lamination
process.
E42
The heater module fails to return
to its original position.
Description
Error
Messages
Solution
If the error message persists though the
cards are loaded, please contact the service
representative for assistance.
W10
Film near the end Warning : when
the remaining film count is 40 or
less.
Prepare the new film and replace the film
when the film has ended. The Error code
for finished film is E22.
E26
If there is no card inside the laminator or
slot, the system goes back to normal. If the
problem persists, please contact the service
representative for assistance.
Jam occurs when there is no lamination
in progress.
Turn off the power, remove the cartridge
and eject the card rotating knob on the
backside. If the problem persists, please
contact the service representative for
assistance.
Jam occurs during the lamination process
W11
Cleaning Warning : When the remaining
film count is at 40 cards or less and
laminated cards count is over 500 after
the last cleaning.
W30
Cleaning Warning: when the Laminated
card count is over 500 after the last
cleaning.
Clean the inside of laminator refer to
page 63.
'Clean Roller Using Cleaning
card' and prepare to replace the film.
Clean the inside of laminator refer to
page 63.
'Clean Roller Using Cleaning
card' and prepare to replace the film.