06
Engine Mount & Pipe Assembly
126312C
3x12mm
Steel Cap Screw
126412EN
4x12mm
Steel Flat Round Engine Mount Screw
561366
3mm
Steel Flanged Nut
561366
3x25mm
Steel FH Screw
Bend the wire appropriately
Now we set the main gear to
pinion gear spacing, known
as gear mesh. Make sure
you can still slide your
engine, then mesh the clutch
bell pinions with the main
gear. The correct gear
spacing is when the pinion is
close to the main gear, but if
you hold the clutch bell, you
should still be able to rock
the main gear back and forth
slightly with light pressure.
Roll the gears and check the
mesh in several different
locations on the main gear.
Then, tighten the four motor
screws. For more
information, please check
Gear Ratio setup page.
12
Pipe
(Not Included)
126312C
126412EN
561366
2.5
2.5
5.5
