8
esc setup procedure
� Battery Selection:
When the ESC is turned on the LED will flash for 2 seconds to indicate the Selected Battery Type.
While the LED is flashing you can press the button to select the other battery type.
After the button is pressed the LED will be flash for 2 more seconds.
A. Turn on ESC and push the button once within 2 seconds to change the battery type -
pushing the button again will toggle between LiPo/NiMh battery types.
B. Red light will select a LiPo battery and 6V cutoff
C. Green light will select a NiMh battery and 4V cutoff
� One touch End-Points Setup:
A. Turn on the Transmitter with the throttle in the neutral position.
B. Press the button and turn the ESC ON - release when the red/green LEDs light up.
C. When the green LED flashes pull the throttle to the full forward position and hold until the green LED
stays on solid. Release the throttle to the neutral position.
D. Wait until the red LED flashes then push the throttle to the full reverse position and hold until the red LED
stays on solid.
E. Release the throttle to the neutral position and the ESC will return to the Battery Selection mode as
mentioned above.
� ESC Mode Selection:
During normal operation, GREEN LED indicates the ESC is in the motor off position:
Forward/Reverse Mode = GREEN LED is on solid
Forward Only Mode = GREEN LED is flashing fast
During Normal Operation, pressing the setup button over 2 seconds will select the
alternate mode.
The Transmitter
1.
Steering Wheel
: Controls direction (left/right) of the model.
2.
Throttle Trigger
: Controls speed and direction (forward/
reverse) of the model.
3.
Antenna
: Transmits signal to the model.
4.
On/Off Switch
: Turns the power on for the
transmitter operation.
5.
Indicator Lights
: Green (top) light indicates adequate battery
power. Red (bottom) light indicates signal strength.
6.
Steering Trim (ST. TRIM)
: Adjusts the “hands off” direction
of the model.
7.
Throttle Trim (TH. TRIM)
: Adjusts the motor speed to stop
at neutral.
8.
Steering Rate
: Adjusts amount front wheels move when the
steering wheel is turned left or right.
9.
Steering Reverse Switch (ST. REV)
: Reverses the function of
the steering when the wheel is turned left or right.
10.
Throttle Reverse Switch (TH. REV)
: Reverses the function of
the speed control when pulled back or pushed forward.
11.
Bottom Cover
: Covers and holds the batteries powering
the transmitter.
2
1
7
6
9
5
8
11
10
4
3
