Page 5
The Transmitter
1.
Steering Wheel
: Controls direction (left/right) of the model.
2.
Throttle Trigger
: Controls speed and direction (forward/
reverse) of the model.
3.
Antenna
: Transmits signal to the model.
4.
On/Off Switch
: Turns the power on for the
transmitter operation.
5.
Indicator Lights
: Green (top) light indicates adequate battery
power. Red (bottom) light indicates signal strength.
6.
Steering Trim (ST. TRIM)
: Adjusts the “hands off” direction
of the model.
7.
Throttle Trim (TH. TRIM)
: Adjusts the motor speed to stop
at neutral.
8.
Steering Rate
: Adjusts amount front wheels move when the
steering wheel is turned left or right.
9.
Steering Reverse Switch (ST. REV)
: Reverses the function
of the steering when the wheel is turned left or right.
10.
Throttle Reverse Switch (TH. REV)
: Reverses the function
of the speed control when pulled back or pushed forward.
11.
Bottom Cover
: Covers and holds the batteries powering
the transmitter.
12.
Binding LED
: The orange LED blinks when the transmitter is
binding to the receiver. A solid light indicates binding process
completed successfully.
Re-Binding the Transmitter to the Receiver
The Losi DSM radio system included in the Mini-LST2 operates on 2.4 GHz, and provides 79 different channels
which are automatically selected when the transmitter and vehicle are turned on. The communication between the
transmitter and receiver begins in the few seconds after the transmitter and vehicle are both turned on. This is called
the “binding process.” The Losi DSM radio system will not interfere with previous technology radio systems that
operate on 27 MHz or 75 MHz frequencies and you will not receive any interference from them.
Although set at the factory, below are the steps required to re-bind your transmitter to the receiver should the need
arise. During the bind process there is a unique ID from the transmitter communicated to the receiver to ensure
trouble-free radio operation.
Steps to Re-Bind
1. Ensure that the transmitter and vehicle are both turned off.
2. Using the supplied Bind plug (which looks like a standard receiver plug with a wire loop installed) insert or plug
into the receiver slot labeled “BIND”. Looking down on the receiver this slot would be below the LED and is the
farthest from the LED, or nearest to the corner of the receiver.
Note
: You do not need to remove any of the other plugs to re-bind.
3. With the Bind plug installed, turn on the vehicle. Notice a blinking Orange LED within the receiver.
4. Now you are ready to turn on the transmitter. You should notice on the back of the transmitter a similar blinking
Orange LED under the translucent cover.
5. Both the receiver and transmitter blinking Orange LED will stop blinking and become solid, indicating they have
“bound” themselves together.
6. Please turn off both the vehicle and transmitter to remove the Bind plug from the receiver. Failing to remove the
Bind plug will cause the transmitter to attempt to re-bind every time you turn on the vehicle and transmitter.
7. Turn on both the vehicle and transmitter to ensure operation. If the transmitter does not control the vehicle, please
repeat steps 1–6. Should this not correct the problem please call Horizon Service/Repair for further assistance.
8. The Bind process is complete. Your vehicle’s radio system should be ready for use.
12
10
3
6
7
1
4
5
8
2
11
9
