15
Desert buggy xl-e • INstructIoN maNual
ENGLISH
ESC fuNCTIONS
D
esc led stAtus
•
No ESC LEDs will glow when there is no throttle input from the transmitter.
•
The red ESC LED glows when there is any throttle input from the transmitter.
AudiBle WARning tOnes
1. input Voltage:
The ESC checks the in put voltage when it is powered ON. If a voltage problem is detected, the ESC continuously sounds 2 beeps with a 1
second pause (xx-xx-xx). Power OFF the ESC and ensure the connections are secure and that the battery power is not too low for safe operation.
2. Radio connection
: The ESC checks radio signal input when it is powered ON. If a problem is detected, the ESC continuously sounds 1 beep with a 2 second
pause (x--x--x). Power OFF the ESC and ensure the radio system is operating correctly.
esc cAliBRAtiOn PROceduRe
Ensure proper ESC function by calibrating the ESC to your transmitter inputs.
1. Power OFF the ESC.
2. Ensure your transmitter is powered ON, the throttle is not reversed, the throttle trim is neutral and the throttle travel range is at 100%.
Disable any special functions such as ABS, etc.
3. Press the SET button while powering ON the ESC. Release the button as soon as the red LED starts to flash.
4. Calibrate the throttle points by pressing the SET button once after each step.
• Neutral (1 flash)—leave the throttle at rest, untouched
• Full throttle (2 flashes)—pull the throttle fully back
• Full brake/reverse (3 flashes)—push the throttle fully forward
5. The motor will run 3 seconds after the last step is completed.
tip:
If the motor turns in the wrong direction, reverse the connection of any 2 outside motor wires. The center wire must remain in the center and cannot be moved
to another motor tab.
Specifications
type
Sensorless
Constant/peak
160A/1050A
Resistance
0.0002ohm
function
forward with Brake, forward/Reverse with Brake
operation
proportional forward, proportional reverse with braking
input Voltage
3-8s lipo
BeC output
6V/8.4V, 6A
overload protection
motor lock-up protection, low-voltage cutoff protection, thermal protection, overload protection and fail safe
(throttle signal loss protection)
dimensions (lxwxh)
70mm x 65mm x 45.5mm
weight
288g
