Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
10
TKG VT 1018 - 151120
Assembly page 10/49
Fax +32 2 359 95 50
It is absolutely necessary to unplug the appliance before
assembling the base or any other part or before disassembling it.
Make sure the assembly is correctly made before plugging in the
appliance. Never try to start the appliance without its protection
guard.
Make sure the appliance is switched to the "0" position before
unplugging it.
Do not insert your fingers, pencils, or any other objects in the
protection guard.
Do not touch the appliance with wet hands.
Do not put the fan on a window sill or any other unsteady place.
Make sure the appliance is put on a flat surface in order to avoid
vibrations.
When used in an inappropriate manner the appliance could
constitute a danger to the user, in that case the producer cannot
be held responsible for any kind of possible damages.
Do not let the fan in use for long periods during your absence.
Make sure it is switched off before leaving.
Do not point the fan in the direction of a sick or sleeping person.
When cleaning the appliance, do not disassemble the guards,
check the cleaning section.
(*) Competent qualified electrician: after-sales department of the producer or importer or any person
who is qualified, approved and competent to perform this kind of repairs in order to avoid all danger. In
case of need you should return the appliance to this electrician.
ASSEMBLY
1.
Unscrew the screws on stand A and stand B and place stand A on stand B to form an X-
base.
2.
Attach the 4 small feet onto the ends of stand A and stand B.
3.
Place the lower pipe (13) with pipe support on the X-base and fix it with the four screws
provided.
4.
Loosen and remove the pipe connector (12) from the lower pipe (13). Slide the plastic
base cover over the lower pipe on the base. Extend the upper (inner) pipe (11) and slide
the pipe connector (12) over the upper pipe onto the lower pipe and tighten.
5.
Unscrew the knurled bolt (10) but make sure that the hex nut remains attached on the
inside. Attach the motor (6) with speed regulator (8) onto the upper pipe (11) and tighten
the knurled bolt (10).
6.
Loosen the guard mounting ring (3) from the motor housing (6).
7.
Position the rear guard (4) firmly against the motor housing (6) in such a way that the small
hole for the reinforcement screw is at the bottom of the rear guard, and fasten by turning
the guard mounting ring (3) clockwise tightly.
8.
Push the blade (2) along the motor shaft (5). Fasten it firmly with the cap by turning
counter clockwise.
