Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
Fax +32 2 359 95 50
•
When you remove the jug from the appliance, a non-drip valve will automatically operate
to stop any drops of coffee dripping onto the hotplate. Replacement of the carafe
automatically opens the non-drip valve and allows remaining coffee to filter through into
the jug.
•
Wait until the brewing process is finished and the filter has run empty before removing the
jug.
•
You can switch off your appliance anytime simply by pressing the on-off switch once (all
pilot lights will be off).
•
Your coffee maker will switch off automatically 1 hour after it has stopped brewing coffee.
PROGRAMMING THE COFFEE MAKER
To programme your coffee maker to brew fresh coffee at a preset time, first follow steps 1 to 7
in the “PREPARATION OF COFFEE” section.
Make sure the coffee maker’s clock is set to the right time.
Press the PROGRAMME button twice. The clock will now display 12:00. Use the HOUR and MIN
buttons to set the desired brew time. Once the setting is finished, wait about 3 seconds or press
once the PROGRAMME button. In both cases the programming time will disappear and will be
replaced by the clock time.
Press the on-off switch (0/I) once to activate the preset brew cycle. The red AUTO light will
illuminate when the brew time is properly set.
When your preset brew time is reached and the coffee maker starts its brew cycle, the AUTO
light will go out and the red pilot light of the on-off switch will illuminate.
As with the regular brew cycle, an automatic one-hour keep-warm cycle will commence after
your coffee maker has finished brewing. When the hour is over, the coffee maker will
automatically shut itself off.
Note: to check the programming time after you have set it, press the PROGRAMME button and
it will be displayed.
USE COMFORT
•
If you use the aroma function, the water flow will be slower which will give your coffee
extra flavour.
•
When you remove the carafe from this appliance, a non-drip valve will automatically
operate to stop any drops of coffee dripping onto the hotplate. Replacement of the
carafe automatically opens the non-drip valve and allows any remaining coffee to filter
through into the carafe.
•
When the water tank is empty, wait a few seconds before removing the carafe in order to
let the water in the filter flow totally.
•
Once the coffee ready, you can keep it warm by letting it on the hotplate. This will start to
heat up as soon as the coffee maker is on (red pilot light of the on-off switch on). With the
automatic or the manual operation, the duration won’t exceed about 1 hour because
your coffee maker will switch off automatically after that.
•
Never put an (almost) empty jug back on the hotplate when the latter is still hot.
•
Caution: when you switch your coffee maker off, the hotplate will also switch off, but it will
still stay hot for a short while. So pay attention and wait until the hotplate has completely
cooled down before cleaning or storing the appliance.
10
TEAM KM 29 T -
091201
Assembly page 10/40
