12
ASSEMBLY INSTRUCTIONS
STEP VII:
Side burner
Loosen side burner in side shelf. To loosen, unscrew and remove two front
screws and washers holding side burner in place. Note: Do not loosen
electrode screw.
Remove knob and bezel from side burner control valve. To remove, pull knob
straight out from valve stem. Unscrew bezel from valve face and set the two
screws aside.
Insert valve stem through hole in fascia. Attach bezel to fascia and valve
face with previously removed 2 screws.
Place side burner tube over the valve, making sure that valve is inside side
burner tube as shown.
Reattach side burner to side burner shelf with the 2 previously removed
screws and washers.
Push control knob onto side burner valve stem.
Replace side burner grate.
Connect both igniter wires to the igniter module on the inside of the right
fascia. To connect, push igniter wire tips onto pins in igniter module.
Unscrew igniter cap from control panel. Insert (1) AA battery (not provided)
into battery slot with positive end (+) facing outward. Screw igniter cap back
onto panel.
