Teac LPU190, Руководство пользователя

Страница: 15 / 38

1
2
Replacing the Turntable Stylus (Needle)
We recommend that your stylus should be replaced regularly for best playback results.
Removing the old stylus
1.
Set a screwdriver at the tip of the stylus and push
down in the direction (A).
2.
Remove the stylus by pulling it forward and down.
Installing a new stylus
1.
Make sure you have a new 402-M208-165 stylus.
2.
Hold the tip of the new stylus and insert the other
end by pressing in the direction (B).
3.
Push up in the direction (C) until it locks at the tip.
L ISTENING TO RADIO
1.
Press the FUNCTION button repeatedly to switch to TUNER function.
2.
Press the STOP/BAND button repeatedly to select FM or AM.
3.
Press

and

repeatedly to tune into stations by adjusting the frequency manually.
To tune faster, hold down

or

until the unit starts running through the frequency
range, and release the button when you reach the desired requency.

NOTE:

The ST indicator will appear on the display when a stereo radio is broadcasting, while
the MONO indicator will show when the signal becomes weak.

If the reception is poor in the following band:
AM: Turn the unit to find the best position for AM reception.
FM: Extend and turn the FM antenna to find the best FM reception.
Using Preset Stations
For convenience, store your favourite stations in the unit’s memory so that you can tune into
them immediately.
1.
Tune into the desired station using the steps described above.
2.
Press the MEMORY/MODE button. A number between 1-20 will flash on the display.
This number depends on which preset station number was used last.
3.
Press MEMORY/MODE button again to memorize the radio.
To listen to preset stations in TUNER Mode, press the PLAY/PAUSE (
 
) button repeatedly
to cycle through preset stations in sequence.

NOTE:

You can store up to 20 stations on this unit, which automatically chooses the next
station preset number on the list every time you store a preset. After the 20
th
station
is saved, the next station will be saved into the 1
st
station preset number, and the
count begins again.

When you store a new station into an existing preset station, the existing station
settings will be overwritten.