Rear Panel
TEAC DVD-ROM Installation Guide
—
2—
eject button:
Press this button to open or close the disc tray. (Some DVD and
CD-ROM titles disable the manual eject button and rely on software commands
to eject the disc. Refer to the documentation for these titles for more
information.)
disc tray:
Use the disc tray to load discs into the drive. Open the tray by pressing
the eject button. Close the tray by pressing the eject button.
Rear Panel
analog audio output connector:
Use the included audio cable to connect this
connector to the audio input connector on a sound card. Pin assignments from
right to left are described below:
CSEL/Slave/Master configuration jumper:
The DVD-ROM drive includes
five pairs of jumper pins on the rear panel. Three of these pairs enable you to set
the drive to CSEL, Slave, or Master mode. (See “TEAC 16X DVD-ROM Drive
Installation Guide (this manual)” on page 3.)
interface connector:
Use an IDE interface 40-pin ribbon cable to connect the
DVD-ROM drive to an IDE interface connector in your computer. (See
“Installing the DVD-ROM Drive” on page 4.)
power connector:
Connect the power connector to the +5VDC and +12VDC
power sources. The +5VDC terminal is on the left as you face the rear panel; the
+12VDC terminal is on the right. The two center terminals are ground terminals.
Operation
LED Indication
At tray loading
green LED flashes
At tray eject
green LED flashes
During audio play
green LED flashes
During seek/data transfer
green LED lights up (steady)
At system/drive start-up
green LED flashes
Self-diagnosis error
green LED flashes
Note: Do not push the tray to close it. Instead, always press the eject button to
eject or retract the tray.
Pin Number
Audio Signal
Pin Number
Audio Signal
1
Left signal
3
Ground
2
Ground
4
Right signal
CSEL/Slave/Master
IDE interface
connector
power
connector
configuration jumper
analog audio
connector
DVD 16X_short.fm Page 2 Wednesday, November 27, 2002 11:44 AM
