Teac CD-W540E, Руководство пользователя

Страница: 13 / 42

Rear Panel
TEAC CD-RW Drive User’s Manual 5
Rear Panel
Figure 3 illustrates the rear panel of the CD-RW Drive.
Figure 3. Rear Panel of the CD-RW Drive
S1: Reserved for factory use only.
analog audio output connector: You can use an audio cable to connect this
connector to the audio input connector on a sound card. Pin assignments are
described in the following table:
CSEL/Slave/Master configuration jumper: The CD-RW drive includes
three pairs of jumper pins on the rear panel that allow you to set the drive to
CSEL, Slave, or Master mode. (For more information, see“Configuring the
CD-RW Drive” and Figure 5 on page 7.)
interface connector: Use the included IDE interface ribbon cable to connect
the CD-RW drive to an IDE interface in your computer. (For more
information, see “Installing the CD-RW Drive” on page 8 and Figure 7 on
page 9.)
power connector: Connect the power connector to the +5VDC and +12VDC
power sources. The +5VDC terminal is on the left as you face the rear panel;
the +12VDC terminal is on the right. The two center terminals are ground
terminals. (For more information, see “Installing the CD-RW Drive” on
page 8 and Figure 7 on page 9).
FG: Frame ground. This is a ground connection for the CD-RW drive.
Pin Number Audio Signal
1 Left signal
2 Ground
3 Ground
4 Right signal
CSEL/Slave/Master interface
connector
power
connector
frame
ground configuration jumper
analog audio
connector
S1
TEAC40x12x48.book Page 5 Sunday, March 17, 2002 7:27 PM