background image

TECP-90-703 • Issue 1 • 8/2012

Page 8

© 2012 Tyco Electronics Corportation. All Rights Reserved.

6

WHERE TO FIND OTHER INFORMATION

6.1

Adapter Pack and Module Installation Instructions

Refer to the laminated cards hanging on the rear of the frame.

6.2

Routing of Cables, Fibers, and Patch Cords

For cable routing on the rear of the frame, refer to the laminated cards hanging on the rear of the
frame. For patch cord routing, refer to the laminated cards hanging on the front of the frame.

6.3

Phone Numbers, Mail Address, Email Address, and Product Portal

Refer to banner below.

Note:

This product is designed for use with RBR (Reduced Bend Radius) fiber.

13944-U

Contents herein are current as of the date of publication. TE reserves the right to change the contents
without prior notice. 

In no event shall TE be liable for any damages resulting from loss of data,

loss of use, or loss of profits and TE further disclaims any and all liability for indirect, incidental,
special, consequential or other similar damages. This disclaimer of liability applies to all products,
publications and services during and after the warranty period.

PRODUCT PORTAL:

PDF copies of this manual and other DELTAccess manuals are available
for downloading using a visual regonition app on a smartphone
and the QR code on the front of the frame

PRODUCT INFORMATION AND TECHNICAL ASSISTANCE:

[email protected]

Publication Number:

WRITE:

Tyco Electronics Corporation
PO Box 1101,
Minneapolis, MN 55440-1101, USA

PHONE:

U.S.A. or CANADA

Sales:  

 

1-800-366-3891

 Extension 

 

73000

 

(Direct                   1-952-917-3000)

Technical Assistance:  1-800-366-3891
 Extension 

 

73475

 

(Direct                   1-952-917-3475)

TECP-90-703

Содержание TECP-90-703









Отзывы: