TECP-90-703 • Issue 1 • 8/2012
Page 6
© 2012 Tyco Electronics Corportation. All Rights Reserved.
5
DOOR INSTALLATION AND OPERATION
The standard chassis is equipped with a separately packed door that when installed protects the
access trays when the chassis is not being accessed.
To install the door:
1. Position the door at a 90 degree angle with respect to the chassis to align the tabs with the
slotted hole, as shown in
Figure 4
. Push out slightly on the mounting arms to clear the
brackets, allowing the tabs to slide into the slotted hole.
2. Retract the slides and flip up the door to snap the door into a closed position as shown in
Figure 5
.
To open the door:
1. Grasp the door at the top and unsnap it from the chassis.
2. Allow the door to hang down in the full open position shown in
Figure 6
.
To close the door:
Retract the slides and flip up the door to snap the door into a closed position as shown in
Figure 5
.
Figure 4. Lining Up Door With Slots
ALIGN TABS
WITH SLOTTED
HOLE
EXTEND SLIDES
AND BEND TO
CLEAR BRACKET
25073-A