408-2823
Rev
AB
9
of 13
4. Try to insert the NO-GO element into the same crimping chamber. The NO-GO elemen can start
entry, but must not pass completely through the crimping chamber. See Figure 7.
If the crimping chambers conform to the crimping chamber inspection, the tool is considered
dimensionally correct, and should be lubricated with a
thin
coat of any good SAE 20 motor oil.
If not, return the tool for further evaluation and repair. See section 7, REPLACEMENT AND
REPAIR.
Figure 7: Gaging the crimping chamber
6.
CONVERTING OLD TOOLS TO SINGLE RATCHET PAWL
To convert an existing tool to single ratchet pawl, use the retrofit kit that corresponds to the frame type of
your tool (Table 5). Refer to instruction sheet
Table 5: Retrofit kits
Frame type
Retrofit kit
Stamped
2119486-1
Solid
2119486-2
7.
REPLACEMENT AND REPAIR
Customer-replaceable parts (
