ADCP-92-159 • Issue 1 • 2/2015
Page 5
© 2015, Tyco Electronics Corporation
The 1RU termination and splice panel has one splice tray. The 2 RU termination and splice
panel has two splice trays.
The panel can be installed on either a 19-inch or 23-inch rack WECO or EIA rack with a 2-, 5-,
or 8-inch recess. The panel is shipped with 23-inch mounting brackets installed in the 2-inch
recess position. An alternate 19-inch mounting bracket is provided.
Figure 4. FPX 2RU Panel External Features
2
BASIC INSTALLATION
Basic installation consists of procedures done for every type of FPX fiber panel, selecting the
mounting bracket location and reconfiguring the brackets if desired, installing the panel on an
equipment rack, installing the vertical cable guides, and grounding the panel. Instructions for
these procedures are provided below.
Additional procedures, after basic installation, are required for specific types of panels. For a
table summary of these procedures, see
Warning:
Never install equipment in a wet location or during a lightning storm. When
installing or modifying communication lines, disconnect lines at the network interface before
working with uninsulated lines or terminals.
REMOVABLE REAR
COVER PROVIDES
EASY ACCESS FOR
CABLE ROUTING
AND MANAGEMENT
RADIUS LIMITERS
FOR CABLE
MANAGEMENT (8)
HINGED
FRONT
DOOR
DESIGNATION
LABEL (2)
DOOR
LATCH
BULKHEAD
ACCOMMODATES
ADAPTER PACKS OR
MPO CASSETTES
OSP CABLE ENTRY
(EITHER SIDE)
MOUNTING
BRACKET (2)
25679-A
SPLICE
TRAY LOCATION
CABLE CLIP
(2 PER SIDE)
SLIDING
TRAY
