114-151049
Rev A
9
of 11
3.11. Panel Mounting
Insert the header through the panel cutout then secure the header using 10-32 hardware (M5 for C023
and CG01 modifications). DRC10-24P requires 0510-014-2406 flange seal (sold separately). Mounting
hardware (i.e. screw, washer, nut) are customer supplied. Screw length depend on application.
Recommended torque: 2.26-2.83 [20-25 in-lbf].
Recommended panel thickness is 6.25 [.250] max.
Note:
1)
Mounting torque not to damage connector or panel
3.12. Replacement and Repair
Damaged or defective header must not be used. It may be removed from the PCB by normal desoldering
methods and replaced with a new header.
4. QUALIFICATION
Refer to product specification
for qualification and approved agency.
5. TOOLING
No special tooling is required for hand placement of the header onto the PCB or installation of the mating
plug connector.
PCB
Washer 4X
Screw 4X
PCB
Screw 4X
Washer 4X
Nut 4X
Panel
0510-014-2406
