409- 10055
Rev F
6
of 8
4. Insert the two outer quick--release pins through the holes in the adapter, and through the holes in the
two outer tabs of the crimping head.
The quick--release pins will “snap” into position when they are properly inserted.
5. Insert the center quick--release pin into the adapter and through the holes in the ram and the
moveable die of the crimp head.
The quick--release pin will “snap” into position when it is properly inserted.
3.2. Removal of Crimping Heads
To avoid personal injury, remove the battery before removing the crimping heads.
To remove the crimping head, it will be necessary to remove the quick--release pins and the crimp head from
the battery powered crimp tool.
4. OPERATION
4.1. Battery Installation and Removal (Refer to Figure 1)
The Batteries Directive 2006/66/EC introduces new requirements from September 2008 on removability of batteries
from waste equipment in EU Member States. To comply with this Directive, this device is designed to allow the
rechargeable battery pack to be easily removed by the end--user when it needs to be replaced.
To install the battery, slide the battery into the bottom of the crimp tool until it can go no further. There will be an
audible “click” of the battery lock to indicate that the battery has been properly installed.
To remove the battery, disengage the battery lock by applying pressure on the lock toward the bottom of the
tool and slide the battery away from the tool.
Always dispose of the old battery pack in an environmentally--responsible way, in accordance with local waste
regulations. Where possible, please recycle the battery cartridge. Contact your local authority for details of battery
recycling locations in your area.
4.2. Crimping
The following procedure provides only general information concerning crimping. Refer to the instructions
packaged with the crimping head for detailed information, including wire stripping dimensions and instructions
for positioning terminals and splices in the crimpers.
To operate the CERTI--CRIMP II Battery Powered Crimp Tool 1213805--[ ]:
To avoid personal injury, keep fingers clear of the crimping area.
1. Insert the contact into the dies.
2. Depress the trigger to advance the moving jaw in order to hold the contact in place. Do NOT deform
the insulation barrel or wire barrel.
3. Place a pre--stripped wire in the barrel of the contact.
4. Depress and hold the trigger to complete the crimp. The crimp tool returns automatically to the first
position of its cycle when the crimp is complete.
NOTE
i
NOTE
i
DANGER
NOTE
i
DANGER
DANGER
