408-1542
2
of 6
Tyco Electronics Corporation
Rev
N
Figure 2
5. MAINTENANCE AND INSPECTION
The tool is inspected before being shipped, however
TE recommends that the tool be inspected
immediately upon arrival at your facility to ensure that
the tool has not been damaged during shipment.
Frequency of inspection depends on:
1. The care, amount of use, and handling of the
hand tool.;
2. The presence of abnormal amounts of dust
and dirt.;
3. The degree of operator skill; and
4. Your own established standards.
5.1. Daily Maintenance
1. Remove dust, moisture, and other
contaminants with a clean brush, or a soft, lint--
free cloth. Do NOT use objects that could
damage the tool.
2. Make certain that the retaining pins are in
place and that they are secured with retaining
rings.
3. All pis, pivot points, and bearing surfaces
should be protected with a thin coat of any good
SAE 20 motor oil. Do NOT oil excessively.
4. When the tool is not in use, keep handles
closed to prevent objects from becoming lodged
in the crimping jaws. Store the tool in a clean,
dry area.
Hand Tool
Wire Size
(AWG)
Range
(and
Terminal
Size)
Crimping
Chamber
Marked
Wire Strip Length
Terminal
(Standard)
Terminal
(Long Barrel)
Butt
Splice
Parallel
Splice
46447
22-16
22-16
4 37- 5.16 [172 203]
-----
6.35-7.14 [.250-.281]
7.94-8.73 [.313-.344]
16-14
16-14
12-10
12-10
6.35-7.14 [.250-.281]
4959252
14-12
14-12
4.37-5.16 [.172-.203]
-----
------
49935
525693
574573
22-16
22-16
4.37-5.16 [.172-.203]
6.35-7.14 [.250-.281]
6.35-7.14 [.250-.281]
7.94-8.73 [.313-.344]
49935
525693
574573
1490046-1
16-14
16-14
4.37-5.16 [.172-.203]
6.35-7.14 [.250-.281]
6.35-7.14 [.250-.281]
7.94-8.73 [.313-.344]
47410
49935
525693
574573
1490047-1
12-10
12-10
6.35-7.14 [.250-.281]
-----
6.35-7.14 [.250-.281]
-----
69363
26-24
26-24
3.17-3.97 [.125-.156]
-----
3.57-4.37 [.141-.172]
-----
22-20
22-20
4.37-5.16 [.172-.203]
-----
5.16-5.95 [.203-.234]
-----
24-20
22-20
-----
------
4.37-5.16 [.172-.203]
-----
