background image

25

16

10

REAR

25

16

10

25

16

10

TM

ERG4 COMFORT CRIMP

®

COMPRESSION TOOL WITH SHURE STAKE

®

 MECHANISM

For Installing Ferrules 26-1/0 AWG (0.14-50 mm

2

)

IMPORTANT: 

 

Read and understand all of the instructions and safety 

information in this manual before operating or servicing this tool.

In the event the SHURE STAKE

®

 mechanism must be released, please see Figure 5.

TA04536  D    Page 1 of 2

1. Remove die screws from frame with supplied torx wrench.
2. Choose an appropriate die set to match wire gauge.
3. Insert die set into frame. Ensure the rear side of die set 

faces the main axle of the frame.

4. Install die set screws loosely and close the handles while 

ensuring proper alignment of the die halves.

5. Tighten the die screws with supplied torx wrench.

Die Set Installation

1.2               

Figure 3

Figure 2

1.1               

1.0

INSTRUCTIONS FOR USE

1. Open handles fully.
2. Position ferrule into the 

proper nest. 

3. Close handles slightly to secure 

ferrule. Do not deform ferrule. 

4. Insert stripped wire
5. 

Close handles until the SHURE STAKE

®

 

mechanism cycle has been completed.

For Use With 

Ferrules 26-1/0 AWG (0.14-50 mm

2

)

WARNING

HANDLES ARE NON-INSULATING.

DO NOT CRIMP ON HOT ENERGIZED WIRES.

WARNING

KEEP ALL BODY PARTS AWAY FROM DIE NEST 

DURING GAGING OR CRIMPING PROCEDURE.

Figure 1

Insert

Die Screws

Main Axle

Отзывы: