25
16
10
25
16
10
To release the SHURE STAKE
®
mechanism, push up on the release bar
until the ratchet teeth are disengaged.
SHURE STAKE
®
Mechanism
1. Remove dust, moisture, and other contaminants
with a clean brush or a soft, lint-free cloth.
2. DO NOT use on objects that could damage the tool.
3. Make certain all pins, pivot points, and bearing
surfaces are protected with a THIN coat of any good
SAE No. 20 motor oil. DO NOT oil excessively.
4. Keep handles closed when not in use to prevent
objects from becoming lodged in the crimping dies.
5. Store tool in a cool, dry area.
Figure 5
TA04536 D Page 2 of 2
For parts, service, repair and
calibration, contact the ABB Installation Products Inc.
Tool Service Center at 1-800-284-TOOL (8665).
WARNING
KEEP ALL BODY PARTS
AWAY FROM DIE NEST
DURING GAGING OR
CRIMPING PROCEDURE.
CRIMP ASSIST
®
Foot
Figure 4
1.3
1.4
For larger wire and terminal combinations
that require more force to complete the crimp,
it may be useful to press the tool against a
flat work surface (i.e. worktable, floor, etc.) to
gain more leverage. The patent pending Crimp
Assist™ foot helps stabilize the tool during
this type of operation.
FLAT WORK SURFACE
Place
CRIMP ASSIST
®
foot
flat on surface for
increased leverage.
Maintenance
1.5
tnb.abb.com (U.S./Latin America)
tnb.ca.abb.com (Canada)
abb.com
Warranty: tnb.abb.com/toolregistration
We reserve the right to make technical
changes or modify the contents of this
document without prior notice. With regard
to purchase orders, the agreed particulars
shall prevail. ABB does not accept any
responsibility whatsoever for potential
errors or possible lack of information in this
document.
We reserve all rights in this document and in
the subject matter and illustrations
contained therein. Any reproduction
– in whole or in part – is forbidden without
prior written consent of ABB.
Copyright© 2019 ABB. All rights reserved.
