408-160034
Rev
A
6
of 8
d. Moving Toggle Link Position
NOTE
Tooling Packs only function with the toggle link installed in position #2.
(1) Remove the set screws from the position #1 set screw holes.
(2) Pull out the groove pin.
(3) Move the toggle link to line up with the position #2 groove pin hole.
(4) Install the groove pin into the position #2 groove pin hole.
(5) Install and tighten the set screws into the position #2 set screw holes.
Figure 9
2. Tooling Packs
a. Terminal Drag Pressure
(1) Drag pressure can be increased or decreased by tightening or loosening the nuts that retain
the drag compression springs.
b. Terminal Feed Finger Pressure
(1) Feed finger pressure can be increased or decreased by tightening or loosening the threaded
spring plunger that biases the feed finger against the terminal strip.
Figure 10
