408-35334
Rev
A
4
of 6
4 Crimping
For wire strip length and specific crimp information for each terminal being crimped, refer to the 114 series
application specification listed in section 1.
CAUTION
If the tool holder is equipped with a crimp height (fine adjust) adjustment, you can prevent damage to the terminator, modular
tool holder, or die assembly by starting at setting A on the crimp disc and incrementally adjusting to the specified crimp height.
If the machine has crimp height/shut height adjustment, refer to the applicable 412 series customer manual for guidance.
1. Rotate the handle to lift the wire stopper
2. Insert the terminal into the die assembly and place it on the anvil with the socket end facing the locator.
3. Slide the terminal into the locator until it touches the extrusion pin (Figure 4).
4. Turn the handle back to lower the wire stopper.
Figure 4: Pushing terminal against extrusion pin
1
Extrusion pin
2
Locator
3
Anvil
