408-2331
2 of 6
Rev C
Figure 2
2. Insert conductor into contact wire barrel until
contact butts against cable dielectric, and place
contact in tool head as shown in Figure 2.
3. Push cable IN to hold center contact against and
perpendicular to locator/stop. MAKE SURE that the
raised area on the contact wire barrel is located ON
the crimping die for proper termination.
4. Close tool handles FULLY until ratchet releases
to complete crimp. Note that once the ratchet is
engaged, handles cannot be opened until they have
been fully closed.
3.2. Crimping the Ferrule
Assemble the connector body over the crimped
contact as described in connector instructions and
proceed as follows:
1. Place connector assembly in tool as shown in
Figure 3. MAKE SURE that the ferrule assembled
on the cable is on the upper crimping die, and that
the shoulder on the connector rests against the die,
as shown.
2. Close handles until CERTI-CRIMP hand crimping
tool ratchet control releases to complete crimp.
Figure 3
4. MAINTENANCE AND INSPECTION PROCEDURE
TE Connectivity recommends that a maintenance and
inspection program be performed periodically to
ensure dependable and uniform terminations. Though
recommendations call for at least one inspection a
month, frequency of inspection depends on:
TOOL NO.
220015
CONTACT TYPE
LONG (Min)
Short (Max)
-1
22.02 [.867]
17.45 [.687]
-2
21.36 [.841]
16.81 [.662]
-3
22.02 [.867]
17.45 [.687]
-4
26.04 [1.025]
21.51 [.847]
-6
22.02 [.867]
17.45 [.687]
Содержание 220015 Series
Страница 4: ...408 2331 4 of 6 Rev C Figure 4...
