TE Connectivity 220015 Series, Инструкция

Страница: 5 / 6

408-2331
5 of 6 Rev C
Figure 5
4. The NO-GO gage may enter partially, but must
NOT pass completely through the crimp die closure.
D. CERTI-CRIMP Hand Crimping Tool Ratchet Control
Inspection
The CERTI-CRIMP hand crimping tool ratchet control
feature should be checked to ensure that the ratchet
does not release prematurely, allowing the jaws to
open before they have fully bottomed. Obtain a
0.025 mm [.001 in.] shim that is suitable for checking
the clearance between the bottoming surfaces of the
crimping jaws. Proceed as follows:
1. Position the connector and wire between the
crimping jaws, as described in Section 3,
ASSEMBLY AND CRIMPING PROCEDURES.
2. Hold the wire in place and squeeze the handles
until the CERTI-CRIMP hand crimping tool ratchet
control releases. Hold the handles in this position,
maintaining just enough tension to keep the jaws
closed.
3. Check the clearance between the bottoming
surfaces of the crimping jaws. If the clearance is
0.025 mm [.001 in.] or less, the ratchet is
satisfactory. If clearance exceeds 0.025 mm