408-10215
Rev
C
7
of 8
8.
ADJUSTING THE RATCHET
The ratchet is preset prior to shipment, but it is important to verify the crimp height using a micrometer or
caliper. Use and wear can cause the tool to go out of adjustment. Inspect the crimp height and adjust the
ratchet, if necessary, on a regular basis.
To adjust the ratchet, complete the following steps.
1. Remove the ratchet wheel adjustment screw (
Error! Not a valid bookmark self-reference.
).
2. Rotate the adjustment wheel.
If the crimp height is larger than recommended, rotate the adjustment wheel counter-clockwise (
)
to a higher setting.
If the crimp height is smaller than recommended, rotate the adjustment wheel clockwise (
–
) to a
lower setting.
3. Reinstall the screw.
4. Repeat as required.
If the crimp height cannot be made to conform to the recommended crimp height, replace the tool or die
set. See section 10, REPLACEMENT AND REPAIR.
Figure 5: Ratchet adjustment
1
Adjustment screw
2
Ratchet adjustment wheel
