TDR VMI QUICKSAND, Руководство пользователя

Страница: 5 / 14

Pour about 750ml (or 2 cups) of water into
the drain at the back of the tray well.
Watch the visual water display on the front
of the machine as you fill the reservoir.
Warning: Do not fill past the “MAX” fill line!
Then re-install the Turntable Assembly.
Priming the Water Line
Warning: Failure to prime the Water Line will
cause damage to the disc!
1. Start with the lid in the open position.
2. Place a paper towel over the disc tray to catch the
drips from the nozzles.
3. Tilt the lid forwards to a 45 degree angle so the
drips will land on the paper.
4. Activate the priming process by pressing the “W”
button on the Keypad.
Caution: Make sure that the Turntable Assembly is
installed, so that water does not pour directly onto
the shaft of the main motor! This will ensure that the
water drips out of the nozzle and onto the paper towel,
instead of running down the inside lid cover.
Installing Jet Nozzle Extenders
These small clear pipes simply extend the jet nozzles
so that the water drips directly on to the disc surface.
To install them, simply push them on to each nozzle.
They are to be replaced with every new consumables
pack.
Initial Setup ...continued Installing a Center Hub
Line up the hex shaped opening on the hub with the
hex shaped post between the two sanding pad holders
and push the Center Hub into place.
Spin the Center Hub by hand to make sure that the hub
is centered. If needed, make an adjustment.
Installing Foam Pads
Install each Foam Pad onto the Sanding Pad Holders.
Make sure that each Foam Pad is centered and fully
seated on the Sanding Pad Holder.
Caution: It is important to keep the lid open to prevent
the pads being deformed by the platen. If you would
prefer to keep the Lid closed when the machine is not
in use, make sure to remove the Turntable Assembly.
Installing Sanding Pads
Install each Sanding Pad onto the
Foam Pads. Make sure that each
Sanding Pad is centered and fully
seated on the Foam Pads.
Then re-install the Lid Stopper.
Your VMI Quicksand unit is
now ready to be used!
Page 3