F
IELD
R
EPLACEMENT
P
ROCEDURE
13
REINSTALLING THE DISPLAY INTO THE ASSEMBLY
Tools:
1 - #2 Phillips screwdriver
1 - ESD wrist strap with grounding cord.
To reinstall the display into the assembly, complete the following procedure:
1. Put the ESD wrist strap on and attach the cord to ground.
2. Connect the backlight cables to the driver board.
3. Ensure the display data cable is connected properly to the rear of the display. Route the cable out of
the bracket through the grommet if previously removed. Set the display into place on the standoffs in the
bracket. Ensure the cables are not pinched anywhere.
4. Using a #2 Phillips screwdriver, secure the display in place using the four screws previously removed.
5. Obtain the previously removed gasket. Reinstall the gasket onto the display. Ensure the thicker side of
the gasket is on the side away from the driver board.
