INSTRUCTION MANUAL
ZWP350-1000 Series
TDK-Lambda
<Page>
5/23
CN53 Signal Connector Pin Configuration and Function
CN53 Connector
Hand Crimping Tool : YRS-620 (SPHD-002T-P0.5) or YC-610R (SPHD-001T-P0.5) (JST)
Use maker recommended crimping tool.
The following signal pins shall be connected by jumper connector at time of shipment :
CN53 : +STB terminal (pin No.6) - +RS terminal (pin No.4)
-STB terminal (pin No.5) - -R terminal (pin No.3)
1
3
5
7
2
4
6
8
Pin No. Configuration
Function
1
-R
GND for remote ON/OFF control terminal.
2
+RO
Remote ON/OFF control terminal. External switch is required and switch
open to turn-on power supply. Do not connect to pin 6 and 8, and do not
connect external voltage. If it is connected, power supply might cause
malfunction.
3
-R
GND for remote ON/OFF terminal.
4
+RS
Remote ON/OFF terminal. External switch is required and switch short to
turn on power supply.
5
-STB
GND for standby supply.
6
+STB
Standby supply (5V/0.3A). For further information, refer to 6-8.
7
-STB
GND for standby supply.
8
+STB
Standby supply (5V/0.3A). For further information, refer to 6-8.
Connector
Housing
Terminal Pin
Maker
SPHD-002T-P0.5
(AWG#24 to AWG#28)
or
SPHD-001T-P0.5
(AWG#22 to AWG#26)
B8B-PHDSS(LF)(SN)
PHDR-8VS
JST