TDK-Lambda NV350, Руководство пользователя

Страница: 19 / 27

Page 19 of 27 17158 issue 18, August 2011
NV350 Handbook
Circuit Ref. Description Max. Temperature (°C)
L2, L3, L4 Filter/PFC assy: Choke winding 155
C3, C4 Filter/PFC assy: X capacitors 100
L1 Filter/PFC assy: Boost choke winding 130
C1 Filter/PFC assy: Electrolytic capacitor 60 (105)
T1 Filter/PFC assy: Flyback transformer winding 130
RLY1 Filter/PFC assy: Relay 100
TX1, TX2 Modules: Power transformer windings 130
L1, XL1 B, BH & DB module chokes 130
L1 C & CM module chokes 140
Global option T2 Global Options: Transformer winding 90 (130)
Various All other choke & transformer windings 110
Various All <=10mm diameter electrolytic capacitors 80 (105)
Various All 12.5mm diameter electrolytic capacitors 85 (105)
TX1 DA Module: Flyback transformer windings 100 (130)
XTH101 Primary IMS measured adjacent to XTH101 100 (105)
See component layout drawings below for locations of components. Higher temperature limit (in brackets) may be
used but product life may be reduced.
Input Connections:
Input screw teminals – 6-32 screws with 8.25mm spacing between screw head centres. Screw head
diameter is 6.6mm
Input IEC 60320 – rated 10A/250Vac (15A/132Vac)
Output Connections:
Maximum Torque Settings for Output Screw Terminals: M3 – 0.75Nm
M4 – 1.5Nm
Modules connected in series or parallel
Module outputs can be connected in series. See section on Module Limitations.
Module outputs cannot be paralleled to other modules in the same power supply or paralleled to other modules in
another unit.
Paralleling of modules for redundant operation i.e. Output load does not exceed the load current of single module.
This can be achieved by isolating the outputs using orring diodes.
With this method remote sensing around these diodes is not allowed.