TDK-Lambda LC1202, Инструкция по эксплуатации

Страница: 19 / 50

83494001 Rev H Page 11 of 27
Model LC1202 OEM: This model has a blank front panel and is operated the same as an
LC1202S, from the remote control connector only. It can function as a stand alone unit or
in parallel for increased output power. The basic model LC1202 OEM is supplied by ex-
ternally controlled AC power. It can also be configured with either an internal AC contac-
tor or front panel circuit breaker option.
Figure 7 Model LC1202 OEM
4.2 REAR PANEL
Figure 8 shows the rear panel of the model LC1202L. The REMOTE connector is used
to control the power supply when the CONTROL KEY SWITCH on the front panel is in
the REMOTE position. The INTERLOCK terminal block (internal 24 DC) can be con-
nected to system interlocks to disable the power supply when opened. Jumper the two
terminals together allows the power supply to operate. The INHIBIT connector allows for
easily connecting a pulsed INHIBIT signal when operating from the front panel. The
INHIBIT signal in the REMOTE connector can be used when operating in remote control
mode. The SLAVE connector is used to control model LC1202S power supplies operat-
ing in parallel with an LC1202L "master" unit. The model LC1202S and model LC1202
OEM do not have the INHIBIT and SLAVE connectors.
Note: The Inter-lock terminals are connected to internal 24 VDC circuits and
should never be connected to ground.