26
83503001 Rev G
1.2.8.
Output Connections
Output connections are made to rear panel bus-bars for models up to 100V and to a 4-
terminal wire clamp connector for models above 100V rated output voltage. Either the
positive or negative terminal may be grounded or the output may be floated. Models up
to 60VDC Rated Output shall not float outputs more than +/- 60VDC above/below
chassis ground. Models >60VDC Rated Output shall not float outputs more than +/-
600VDC above/below chassis ground. Contact factory for assistance with higher float
voltage applications.
Local or remote sense may be used. In remote sense, the voltage drop on the load
wires should be minimized. Refer to the specifications for the maximum voltage drop
value.
1.2.9.
Cooling and Mechanical Construction
The Genesys
TM
series is cooled by internal fans. At the installation, care must be taken
to allow free airflow into the power supply via the front panel and out of the power
supply via the rear panel. The Genesys
TM
power supplies have a compact and
lightweight package, which allows easy installation and space saving in the application
equipment.
CAUTION
Observe all torque guidelines within this manual. Over-torquing may damage unit
or accessories. Such damage is not covered under manufacturer’s warranty.
1.3.
Accessories
1.3.1.
General
Accessories are delivered with the power supply or separately upon ordering. The list
below shows the possible accessories and ordering numbers.
1.3.2.
Serial Link Cable
Serial link cable, for linking power supplies by RS485 communication is provided with
the power supply.
Cable description: 0.5m length, shielded, RJ-45 type plugs, 8 contacts (P/N:GEN/RJ-
45).
1.3.3.
Misc. Hardware
DB25 plug (AMP, 749809-9).
Strain relief for AC cord.
Output terminal shield
Output bus bar connection hardware.
Plastic legs for bench mounting.
1.3.4.
AC Cables
AC cables are not provided with the power supply.
Refer to Table 1-2 for recommended AC input cables (customer supplied). Add a non-
locking plug approved by the national safety standards of the country of usage.
