EZA2500 Series
TDK-Lambda
<Page>
12
Mounting
Please install reliable using M4 tap 8 places of the bottom of chassis (see below circle).
The maximum allowable penetration of mounting screws is 6mm.
12-1. Mounting Direction
Recommended standard mounting method (A).
Converter Bottom View
(A)Standard Mounting
(B) Not possible
12-2. Mounting Method
(1) Forced air cooling type converter.
This converter has ventilating holes on the front and rear side panel.
Keep these two areas freely as much as possible.
(2)The maximum allowable penetration of mounting screws is 6mm.
Incomplete thread of mounting screw should not be penetrated.
(3)Recommended torque for mounting screw
M4 screw : 1.27 N
J
m (13.0kgf
A
cm)
19/22
Converter
50mm min
F
A
N
Air Flow
Front
Rear
50mm min
