TCS FBO1200-0400, Информация о продукте

Страница: 5 / 20

04/2013 5
TCS TürControlSysteme AG, TCS Hotline Germany: +49 (0) 41 94/ 9 88 11 88 Subject to technical changes.
FAX: +49 (0) 41 94/ 9 88 129

Mail: hotline@tcsag.de PI_FBO1200-uk 1A
Indication and operating elements
Term Function
Reset push button

for reset, restart the software

to reload the factory settings
button Reload to
factory setting WE

to reload the factory setting
Anzeige
Status TCS:BUS
(rote LED) 
OFF : stand-by

ON : during a voice connection between TCS:BUS and PBX / PSTN

both LEDs ON : when reloading the factory setting

blinks slowly : busy (voice connection or alarming, announcement)

blinks fast : a-wire is not connected or supplied

flashes OFF : device is activated for programming with configuration software
configo™

flashes ON : door call, internal call or sensor signal received

flashes ON, once, long break : a-, P-wire are interchanged or short-circuited

flashes oN, twice, long break : error duplication of the block number and
different device versions

flashes ON, three times, long break : error duplication of the block number
in case of identic devices
Status indication PBX
/ PSTN connection
(yellow LED)

OFF : error P-wire is not connected or not supplied

ON, briefly : as long as a call signal comes in at the TK-Interface

ON : after a door call, during connection establishment and voice connection

both LEDs ON : when reloading to factory settings

blinks slowly : programming mode active

blinks fast : once, connection to the PBX / PSTN cannot be realised, busy

flashes OFF : after a door call with deviated connection etsablishment, until
the end of the delay time

flashes ON : connection to the sensor without speaking

flashes ON, four times, long break : variant dial number from 1 to 99999
Intended use

The FBO1200 is an interface for the connection from the TCS:BUS to a telephone net in
ordert o establish a voice connection between a TCS:BUS client (front-door or indoor
stations) and client with telephone net.

The connection is realised via an analogue port.

Only a FBO1200 can be connected to a TCS:BUS.

Devices type FBO1200 cannot be combined with devices type FBO1100.
!
FBO1100 and FBO1200 must not be connected simultaneously to a TCS:BUS!
Note:
If there is more than FBO1200 connected to a TCS:BUS, this error is signalled by the red LED (flashes
three times, long break, see also Error detection and indication, page 10 ).