TCS FBO1200-0400, Информация о продукте

Страница: 10 / 20

10 04/2013
TCS TürControlSysteme AG, TCS Hotline Germany: +49 (0) 41 94/ 9 88 11 88 Subject to technical changes.
FAX: +49 (0) 41 94/ 9 88 129

Mail: hotline@tcsag.de PI_FBO1200-uk 1A

First, eliminate the following errors:
acknowledgement, description
acoustic
reaction
optical
reaktion
“
The called client“ is busy: acknowledgement after calling a stored
number, if the called client is busy (audible at the front-door station).
yellow LED
blinks fast
Unsuccessful call: acknowlegdement after calling a stroed number, if
the called client is not accepting within a period of time (audible at
the front-door station).
yellow LED
blinks fast
“Dialing register empty“: acknowledgement as reaction to pressing a
bell button, if no call number is entered in the dialing register (audi-
ble at the front-door station).
yellow LED
blinks fast

Then check the system for errors.
Error detection and indication
Errors are signalled potically and acoustically:

After the call at the FBO1200 an error tone sounds for three times (audible at the
telephone), then the connection is disconnedted.

The red LED at the TK-Interface blinks or flashes permantly (see table below).

The optical error indication at the TK-Interface stays active until the error is corrected.
error causes red LED
yel-
low
LED
error tone description, solution
TCS:BUS is busy
blinks
slow
OFF
Acknowledgement after calling the
FBO1200, if a voice connection is acti-
vatetd at the TCS:BUS or an alerting or
announcement is running (audible at
the telephone).

After a timeout of 5 min the status
must be finished
a- and P-wire
interchanged or short-circuited
flashes OFF
Every 2 min the system is checked if
the error still exists.

exchange a- and P-wire or eliminate
the short-circuit, device is in stand-
by mode again
BUS error a:
a-wire is not connected or not
supplied
blinks-
fast
ON

connect the a-wire or check the
mains connection, device is in
stand-by mode again
block number error*
another FBO1200 or FBO1100 is
connected
flashes
three
times,
long
break
OFF

press the Reset button

only one FBO1200 can be connect-
ed
* The SN20 bit-function is moved to an invalid area for the TK-Interface (SN 2044, BlNr 128).