TCS ASX1300 -0010 Series, Информация о продукте

Страница: 11 / 16

11
Labelling the bell button
Labelling templates as WORD files are available for
download at www.tcsag.de .
► Enter the required names into the labelling template.
► Print the nameplates on the special foil by using a laser
printer.
► Alternatively label the special foil with a waterproof marker.
► Cut out the nameplate along the marking (W x H 31 x 12
mm).
► Remove the cap of the bell button with the special wrench
(1)
.
► Place the nameplate back-to-front in the cap. (Fig. 9).
► Snap-in the cap on the bell button with light pressure.

Condensation water can form inside the bell button.

Do not use nameplates made of paper.

We recommend to print out the nameplates on a
durable special foil made of plastics.

You can order replacement foils directly under E-
Mail: info@tcsag.de or use our labelling service:
www.tcsag.de.
Fig. 8: Open the bell button
Fig. 9: Placing the nameplate
Connecting the lines
Connecting lines
Permissible cross-section:
– single-wire and fine-wire 0,2 … 0,75 mm
2
Connect further wires by using auxiliary terminals.
Use only connecting lines made of the same material and with the same diameter within one
terminal contact.
General information

Use the small slot screwdriver (enclosed in the delivery) to connect lines. Avoid damaging
the device.

Ensure that no lines are clamped on the backside of the front door station or between the
upper part of the housing and the rear panel.