TCO ICon Pro, Руководство пользователя, Страница: 25 / 33

25
7 Maintenance
7.1 Replace the pre-filter
1.
Unscrew the Allen screws (4x - Figure 17,
pos.4) of the pre-filter compartment panel
(Figure 17, pos. 3) with the provided 2.5mm
Allen wrench (Figure 17, pos.1)
NOTE : The Allen wrench is attached to the
inside of the main HEPA filter compartment
panel).
2. Remove the compartment panel (Figure 17,
pos.3).
NOTE : There is a ground wire (Figure 17,
pos. 2 ) connecting the compartment panel
and the main ICon Pro unit.
DO NOT
disconnect it from the main ICon Pro unit.
3. Pull the filter lock (Figure 18, pos. 1)
forward and push it down.
4. Take the pre-filter by the handle on the
front of the filter (Figure 18, pos. 2) and
carefully pull it out of the compartment.
5. Put the old filter in the plastic bag supplied
with the new filter.
6. Seal the plastic bag and follow the
instruction on the bag for disposal.
WARNING
•
Always switch off and unplug the unit before replacing the pre-filter filter.
•
Always use the replacement filters recommended by your ICon Pro supplier.
Figure 17
Figure 18