TCL RF436GM1110, Руководство по обслуживанию

Страница: 24 / 29

Disassembly of air duct cover plate of the freezer compartment:
Buckle
1
2
3
1. Unscrew the set screw from the middle separator of the freezer compartment with the cross screwdriver, install based on the illustrated
method, slightly pull the false beam with the left hand, and pull out the middle separator from the illustrated position with the right hand;
2. Slightly pry the joint between the air duct cover plate and the cabinet liner with the straight screwdriver or other pry bars, (release the left
and right buckles before the middle buckle), as shown in the figure, pull slightly the buckle outwards to one side for releasing while the
other hand holds the air duct opening, release the right and middle buckles with the same method, and then release the upper buckle
downwards; pay attention to the strength when prying and slightly pulling the air duct, and don't damage the air duct and the cabinet liner;
3. Remove the connector, slightly take out the air duct, remove the aluminum foil sealed foam adhered to the surface (the aluminium foil
sealed foam is easily damaged during the disassembly, so it is suggested to find out the screw and buckle positions as shown in the figure,
tear in a small range, apply the aluminium foil to the damaged and seal it completely if there is no reserved one for replacement), unscrew
the screw identified with the black ring, release the buckles around the air duct with the straight screwdriver, suggest finally releasing the
buckle at the purple identification, as shown in the figure, make the straight screwdriver protrude into the buckle at the red identification to
slightly release the buckle, open the cover plate, and remove the set screw from the fan to replace it;
4. Pay attention to installing the buckles at other three sides in place after installation in the purple identification area, and seal them in
place to prevent air leakage.