Factory Test & Alignment Specification For MS08PA-LA Series (V1.0).Doc
Page 16 of 18
of an available wireless router to setup the connection.
-1.2.3.3
Auto
If your AP supports WPS (Wi-Fi Protected Setup), you can connect to the network via PIN (Personal
Identification Number) or PBC (Push Button Configuration). WPS will automatically configure the
SSID and WPA key in either mode. Select
Wireless setting > Auto
, then press
OK/
►
to enter.
•
PIN
: Select
PIN
and press
OK/
►
to enter. Generate a random PIN code. Make sure this code is
installed to the AP. (For the procedures, refer to your router manual.) Press
OK/
►
again to setup the
connection.
•
PBC
: If your router has a PBC push button, select
PBC
, then press
OK/
►
to enter. Press PBC
push button on your router within 2
EN
12 minutes after you press
OK/
►
again. Your TV will
automatically acquire all the network setting values it needs and connect to your network.
Network setup
1.
Press
Menu
on the remote control and select
Options > Network > Configuration > Internet connection
. Press
◄/► to select
On
. Wait until
the
connection is automatically established.
2.
Select
Options > Network > Configuration >Connection test
, then press
OK/
►
to check the
Internet connectivity. If fail, follow below step to
make sure the connectivity.
3.
Select
Options > Network > Configuration > IP setting
, then press
OK/
►
to enter the
IP setting
menu.
- Set
Address type
to
Auto
, it will acquire and enter the needed IP address automatically.
- You can follow below steps to enter your IP address manually.
• Set
Address type
to
Manual
, then press
▼ to go to the first entry field.
• Enter the
IP address
,
Subnet mask
,
Default gateway
,
Primary DNS
and
Secondary DNS
values.
Use the digit buttons to enter numbers
and the arrow buttons to move from one entry
field to another.
- After setting, select
Options > Network > Configuration > Connection test
to check the
Internet
connectivity again
.
4.
Select
Options > Network > Configuration> Information
, then press
OK/
►
to display
the
information on current connection, such as
Interface, Address type, IP address, etc..
Share & See
Note: This manual covers products with either
Share& See
or
DLNA
function.
Share & See
is DLNA
compatible.
Connecting to your PC
Make sure to set up a wired or wireless connection from your TV to a router first. Then connect your
PC to your router either through a network cable or wirelessly. Follow the steps in turn specified
hereafter, then you can enjoy recorded video, picture, music and/or text files saved on your PC.
Adding media from your PC for sharing
Install a DLNA media server in your PC. The simple and familiar server you may install is Microsoft
Windows Media Player 11. Allow your TV to share the designated files on your PC.
1.
Open Microsoft Windows Media Player 11.
- Select
Library > Media sharing
.
- Check the checkbox
Share my media to
.
- Select the icon of the TV set connected to your PC.
- Select
Allow
to allow the TV set to access your PC, and select
OK
to enable your allowing.
Note: You can push
Settings
button to customize your desired settings.
2.
- Select
Library > Add to Libray.
- Select your personal folders or folders of other users that you can access for sharing.
- Select
Add
and press
OK
to enable your adding.
Share & See application
