Factory Test & Alignment Specification For MS08PA-LA Series (V1.0).Doc
Page 15 of 18
Appendix
”NETWORK CONNECTION AND TEST”
1.Network connection
You can set up your TV so that it can access the Internet through your local area network (LAN)
using a wired or wireless connection.
1.1Connecting to a wired network
You can attach your TV to your LAN using cable in three ways:
• You can attach your TV to your LAN by connecting the LAN port on your TV to an external modem
using a Cat 5 cable.
• You can attach your TV to your LAN by connecting the LAN port on your TV to a IP Sharer which is
connected to an external modem. Use Cat 5 cable for the connection.
• Depending on how your network is configured, you may be able to attach your TV to your LAN by
connecting the LAN port on your TV directly to a network wall outlet using a Cat 5 cable. Note that the
wall outlet is attached to a modem or router elsewhere in your house.
Select
Options > Network > Configuration >Interface
, then select
Ethernet
to connect to a wired
network.
1.2 Connecting to a wireless network
To connect your TV to your network wirelessly, you need a wireless router or modem and a Wireless
LAN Adapter. Connect your Wireless High Gain USB
Adapter (USB dongle) delivered with your TV to your TV’s
USB 1
port.
1.2.1
Select
Options > Network > Configuration >Interface
, then select
Wireless
to connect to a
wireless network.
1.2.2.
Select
Wireless setting
and press
OK/
►
to enter.
1.2.3. Connection Methods
: You can setup the wireless network connection three ways.
1.2.3.1
Scan
• Select
Wireless setting > Scan
, then press
OK/
►
, the TV will scan all access points within range.
The access points found by the TV will be displayed.
• Select an available access point, then press
OK/
►
to connect the TV to it.
Notes:
- If you select a protected access point, you will have to enter the corresponding password.Press
Menu
on the remote control to display virtual keyboard to enable you to enter the password.
- This set has a memory function of available access point, which enables your set to be connected
to the network even if you switch on TV after power off.
1.2.3.2
Manual
Select
Wireless setting > Manual
, then press
OK/
►
, you will be prompted to enter the correct SSID
