TC Electronic M300, Руководство пользователя, Страница: 15 / 34

13
TYPICAL SETUPS
Guitar Setups
This setup utilizes the M300 as a Multi-
effects processor connected in serial to a
Reverb. It is ideal when you wish to add
Reverb to a signal already processed by
one of the Multi-effects.
This is a typical guitar setup.
• On the rear panel select SERIAL routing by
leaving the switch in the “OUT “ position.
• Connect guitar to preamp Input.
• Connect preamp Output to M300 Left Input.
• Connect M300 Left Output to Input on your
amp. Use the regular Input or the Return on
an effect loop if you use Combos or Heads. If
you are using a regular Power-amp and
speakers simply use the Inputs.
• Set Input level to 12 o’clock position.
• Set MIX level to 12 o’clock position.
• Set BALANCE to 12 o’clock position.
• Adjust/fine-tune the M300 Input level so the
Input LED on the front panel often is Orange
but only rarely peaks at Red color.
• Select Reverb type and Multi-effect type
using the selectors on the front panel.
• Now fine-tune:
- MIX between wet and dry signal
- BALANCE between the two effect Engines.
M300 in an effects loop
• On the rear panel select SERIAL routing by
leaving the switch in “OUT “ position.
• Connect guitar to amp Input.
• Connect effect-loop send to M300 Left Input.
• Connect M300 Left Output to Effect-loop
Return.
• Set Input level to 12 o’clock position.
• If the effects loop is serial type (see owners
manual for the amp) set MIX level to 12
o’clock position.
If the effects-loop is parallel type set MIX to
100% (fully clockwise position).
• Set BALANCE to 12 o’clock position.
• Adjust/fine-tune the M300 Input level so the
Input LED on the front panel often is Orange
but only rarely peaks at Red color.
• Select Reverb type and Multi-effect type
using the selectors on the front panel.
• Now fine-tune:
- BALANCE between the two effect Engines.
Setup
Setup