TC Electronic M2000, Руководство пользователя, Страница: 34 / 37

34
SELF TEST
PRESS ONE OF THE 3 BYPASS KEYS, WHILE POWER-
ING UP, TO ACCESS THE SELF-TEST AND SELECT
»RUN TEST PROGRAM«
Turn the Adjust Wheel to scroll through Self tests
Key test
Select Key test by pressing OK.
The keys must be pressed in the order they are requested by the
M2000 to pass the test.
Press Cancel to exit Key test.
Adjust Wheel test
Select Adjust Wheel test by pressing OK
Turn the Adjust Wheel to 30 and back to 0 to pass test.
Press Cancel to exit Adjust Wheel test.
Led test
Select Led test by pressing OK
Turn Adjust Wheel to test the Leds. The test is “ok” when all
Leds are lit.
Press Cancel to exit Led test.
Display test
Select Display test by pressing OK
Press OK to check that all pixels are lit. Press any key to leave
the pixel test.
Press Cancel to exit Display test.
Analog I/O test
Select Analog I/O test by pressing OK
Connect an Analog Output to the Analog Input, which has to be
tested and press OK.
Use a balanced cable.
PPM must show -12 dB to pass test.
Press Cancel to Exit Analog I/O test
Digital I/O test
Select Digital I/O test by pressing OK
Connect a Digital Output to the Digital Input, which has to be
tested and press OK.
The AES/EBU output can also be connected to the S/PDIF input
and vice versa.
PPM must show 0 dB to pass test.
Press Cancel to exit Digital I/O test.
Midi I/O test
Select Midi I/O test by pressing OK
Connect Midi Out to Midi In.
Prg change 1-128 is send out on Midi Thru. Connect this socket
to a Midi compatible device and confirm the Prg. changes.
Press Cancel to exit Midi I/O test.
Pedal test
Select Pedal test by pressing OK.
Connect a momentary pedal to the Pedal socket.
When pressing the Pedal, the Result should be OK.
When released, the Result should be Not OK.
Press Cancel to Exit Pedal test.
PCMCIA test
Select PCMCIA test by pressing OK
Insert PCMCIA card. Note that all Data on PCMCIA card will be
destroyed.
Press OK to test.
Result reads:
Low battery - Time to change battery in your PCMCIA card.
Not Ok - Try the test using another PCMCIA card.
Press Cancel to Exit PCMCIA test.
Battery test
Select Battery test by pressing OK
Confirm that Result is “ok”.
Press Cancel to Exit Battery test.
System test
Select System test by pressing OK
Confirm that Result is “ok”.
Result reads:
Eeprom Not ok - The unit will most likely work ok, the message
is for service matters only.
DSP Not ok - Contact your local dealer.
Press Cancel to Exit System test.
Power Off - On to start standard software.