DOG TRAINING COLLAR MANUAL
DOG TRAINING COLLAR MANUAL
1
2
Beeping Test:
• Press the Beeping button to test the Beeping Function
• The Receiver Collar will be beeping indicating that the
Beeping Function works
Note:
the level of the Beeping mode can NOT be adjusted. Level
0 is set by default.
3. Fit the Collar Receiver
The proper fit and placement of the collar is important for
effective training. The contact points must have direct contact
with your pet’s skin on the underside of the neck.
To assure a proper fit. Please follow these steps:
• Make sure that the collar is turned Off
• Have your pet standing comfortably on all four legs (
Fig 3A
)
• Place the collar receiver on your pet’s neck close to the ears
• Center the contact points underneath your pet’s neck to
touch the skin (
Fig 3B
)
• The collar should fit snugly yet loose enough to allow one
finger to fit between the strap and your pet’s neck (
Fig 3C
)
Tips:
• Sometimes you need to trim the hair around
the contact points to make sure that contact is
consistent
• DO NOT shave the pet’s neck as this may increase
the risk of skin irritation
• Check the fit again as your pet becomes more
comfortable with the collar
FREQUENTLY ASKED QUESTIONS
Q:
Is the Receiver Collar waterproof?
A:
Yes, the Receiver is fully waterproof.
Q:
Is the Remote Transmitter waterproof?
A:
No, the Remote Transmitter must be kept away from water.
Q:
How long can I continuously deliver Vibration or Static Shock to my pet?
A:
The max amount of time you can deliver the Vibration or Static Shock to your
dog continuously is 10 seconds. Then the remote will go to Protection Mode.
Q:
What should I do if my dog’s neck becomes red and irritated?
A:
Stop using the product immediately for at least 48 hours. If
the condition persists beyond 48 hour please consult your
veterinarian.
Q:
Can I attach a leash to the Receiver collar?
A:
No, this can result in pulling the contact points too tightly against your dog’s
neck. Use a separate collar when needed.
Q:
When should I recharge the Transmitter and Receiver Unit?
A:
Receiver: When the receiver is not in pairing mode but the indicator is
blinking, it indicates that the receiver battery is very low and you need to
charge it.
Q:
How long does the charge last on the collar?
A:
Actually, it depends on how often you use it. Normally the charge lasts about
15 days.
Q:
What is the recommended time to have the collar on the dog?
A:
We recommend using it no more than 12 hours per day.
Q:
Does the remote work when I don’t know where my dog is?
I just know he’s near.
A:
Yes, if he’s in the remote-controlled range.
Q:
What is remote-controlled range?
A:
It is about 1600 ft.
Q:
Will this work through a wall?
A:
Yes, it will. But the wall may affect the remote control range.
Q:
Does the remote have a belt clip?
A:
Yes, it has a belt clip.
Q:
Can I control 2 dogs with 1 remote?
A:
Yes, you can control 2 dogs with 1 remote.
Receiver Collar
:
Collar (receiver) Dimensions
:
Collar material
:
Strap girth
:
Strap material
:
Collar (receiver) weight
:
Remote weight
:
Remote range
:
The RED LED indicator will be blinking
when the Power is low.
6.2cm L x 3.5cm W x 3.2cm H
ABS+PC
64cm
TPU
47g
61.2g
1600 ft, 433MHz
SPECIFICATIONS