DOG TRAINING COLLAR MANUAL
DOG TRAINING COLLAR MANUAL
98
1
1
2
1
2
1
2
1
2
SETUP PROCEDURE:
1. Charge the remote and receiver
• Please, fully charge the Remote and Receiver before you use
the products
• Remote: Fully charged, The Red LED will become solid
• Receiver: Fully charged, the Red LED will become solid (The
LED will be blinking if Low Power)
• The charging time takes around 2 to 3 hours. LED indicator on
the Remote will be solid and LED indicator on receiver will be
blinking when charging
Tips:
• When the receiver is low power, the LED Indicator will
fast blink
• When the system is working or fully charged, the LED
Indicator will be solid
• The receiver will go to Power Saving mode after 30
seconds if no movement or transmitted signal is detected
2. Pairing and Test the remote and
Receiver (important)
1. Turn on the Remote Control,
and turn off the Receiver.
2. Press and Hold the receiver
Power On/Off Button at
least 5 seconds, then you will
hear a Beep and the Red LED
is flashing. (You will have 5
seconds to pair the device).
3. Press the Vibration button within 5 seconds to finish the
pairing then you will hear a Beep.
To test if the Remote and Receiver are paired, press the Beep
button, the Receiver will beep every time you press the beep
button. If there is no Beep, then repeat the pairing process.
Tips:
You can choose Channel 1 or Channel 2 to pair the Remote
and Device. The system can pair 2 Receivers at the same
time. If you can not pair the device successfully, it may be
caused by signal interference. Please, change to another
location. The Remote will go to Sleep Mode if you don’t
use it for 2 minutes or more, and the Receiver will go
to Power Saving Mode if there is no movement for 30
seconds and the LED will be turned off. Any movement
on the Receiver will activate the collar and any button you
press on the Remote will activate the Remote.
Static Shock Test:
• Secure the included test Bulb Kit on
the Receiver Collar’s Contact Points
• Press the Shock button
to test
the Shock Function
• The test Bulb will light up indicating
that the Static Shock Stimulation
works
• The higher the Static Shock Level is
the brighter the light should be
Vibration Test:
• Press the Vibration button to test the Vibration Function
• The Receiver Collar will vibrate indicating that the Vibration
Function works
