Taylor C302NP, Руководство оператора

Страница: 43 / 54

Section 7
7-1
Model C302 NPR
Operator Checklist
7
Operator Checklist
During Cleaning and Sanitizing
Cleaning and sanitizing schedules are governed by your
state or local regulatory agencies and must be followed
accordingly. The following checkpoints should be
stressed during the cleaning and sanitizing operations.
Important! We recommend cleaning and sanitizing
every 120 days.
Troubleshooting Bacterial Count
Regular Maintenance Checks
Winter Storage
If the place of business is to be closed during the winter
months, it is important to protect the freezer by following
certain precautions, particularly if the building is subject
to freezing conditions.
Disconnect the freezer from the main power source to
prevent possible electrical damage.
Your local Taylor distributor can perform this service for
you.
Wrap detachable parts of the freezer such as the beater,
scraper blades, drive shaft, and freezer door. Place these
parts in a protected, dry place. Rubber trim parts and
gaskets can be protected by wrapping them with
moisture-proof paper. All parts should be thoroughly
cleaned of dried mix or lubrication, which attract mice and
other vermin.
Note: It is recommended that an authorized service
technician perform winter storage draining to ensure all
water has been removed. This will guard against freezing
and rupturing of the components.
 
Thoroughly clean and sanitize the machine
regularly, including complete disassembly and
brush cleaning.
 
Use all brushes supplied for thorough cleaning.
The brushes are specially designed to reach all
product passageways.
 
Use the black bristle brush to thoroughly clean
the rear shell bearing located at the rear of the
freezing cylinder. Make sure there is a
generous amount of cleaning solution on the
brush.
 
Using a screwdriver and a cloth towel, keep the
rear shell bearing and the female hex drive
socket clean and free of lubricant and product
deposits.
 
Properly prepare the cleaning and sanitizing
solutions. Read and follow the label directions
carefully. Too strong of a solution may damage
the parts and too weak of a solution will not do
an adequate job of cleaning or sanitizing.
 
Clean and sanitize the syrup lines regularly to
prevent syrup residue build-up that would
restrict the proper flow of syrup.
 
On a regular basis, take a brix reading to
ensure a consistent quality product.
ALWAYS FOLLOW LOCAL HEALTH CODES.
 
Replace scraper blades that are nicked,
damaged, or worn down.
 
Before installing the beater, make sure that the
scraper blades are properly attached over the
pins.
 
Check the rear shell bearing for signs of wear
(excessive product leakage from the rear drip
pans to the front drip tray).
 
Dispose of O-rings or seals if they are worn,
torn, or fit too loosely, and replace with new
ones.
 
Follow all lubricating procedures as outlined in
“Assembly”.
 
Check the condenser for an accumulation of
dirt and lint. A dirty condenser will reduce the
efficiency and capacity of the machine. The
condenser should be cleaned monthly by
removing and cleaning the poly-flo filter.