Taylor 702, Руководство по эксплуатации

Страница: 8 / 43

4
Safety
Models 702/741/772
050323
Section 3 Safety
We at Taylor Company are concerned about the safety
of the operator when he or she comes in contact with
the freezer and its parts. Taylor has gone to extreme
efforts to design and manufacture built-in safety
features to protect both you and the service technician.
As an example, warning labels have been attached to
the freezer to further point out safety precautions to the
operator.
IMPORTANT -- Failure to adhere to the
following safety precautions may result in severe
personal injury or death. Failure to comply with
these warnings may damage the machine and its
components. Component damage will result in
part replacement expense and service repair
expense .
To Operate Safely:
DO NOT operate the freezer without reading
this operator’s manual. Failure to follow this instruction
may result in equipment damage, poor freezer
performance, health hazards, or personal injury.
S
DO NOT operate the freezer unless it is
properly grounded.
S
DO NOT operate the freezer with larger
fuses than specified on the freezer data
label.
S
DO NOT attempt any repairs unless the
main power supply to the freezer has been
disconnected.
Failure to follow these instructions may result in
electrocution or damage to the machine. Consult your
electrician.
DO NOT use a water jet to clean or rinse the
freezer. Failure to follow these instructions may result
in serious electrical shock.
S
DO NOT allow untrained personnel to
operate this machine.
S
DO NOT operate the freezer unless all
service panels and access doors are
restrained with screws.
S
DO NOT remove the door, beater and
blades, or drive shaft unless the control
switch is in the OFF position.
S
DO NOT put objects or fingers in door
spout.
Failure to follow these instructions may result in
contaminated product or personal injury from
hazardous moving parts.
This freezer must be placed on a level surface.
Failure to comply may result in personal injury or
equipment damage.
USE EXTREME CAUTION when removing
the beater assembly. The scraper blades are very
sharp and may cause injury.
DO NOT obstruct air intake and discharge openings:
Counter Model: Minimum of 6” (152 mm) of air space
on both sides. Install the deflector on the right side of
the unit and place the back of the unit against the wall
to prevent recirculation of warm air.
Console Models: Minimum of 3” (76 mm) of air space
around all sides. Install the deflector to prevent
recirculation of warm air.
Failure to follow these instructions may cause poor
freezer performance and damage to the machine.
These freezers are designed to operate indoors, under
normal ambient temperatures of 70
_
--75
_
F
(21
_
--24
_
C). The freezers have successfully
performed in high ambient temperatures of 104
_
F
(40
_
C) at reduced capacities.
NOISE LEVEL: Airborne noise emission does not
exceed 78 dB(A) when measured at a distance of 1.0
meter from the surface of the machine and at a height
of 1.6 meters from the floor.