14
Operating Procedures
Models 441 & 444
150701
Step 3
Before installing the beater assembly, check the
scraper blades for any signs of wear or damage. If a
scraper blade is nicked or worn, replace both blades.
Check the scraper blade clips to make sure they are
not bent and the slot is even for the entire length of the
clip. Replace any damaged clips.
Figure 7
Step 4
If the blades and clips are in good condition, place the
rear scraper blade over the rear holding pin on the
beater, knife edge to the outside.
Figure 8
Note:
To prevent costly damage, the hole in the
scraper blade must fit securely over the pin.
Step 5
Holding the rear blade on the beater, slide the
assembly halfway into the freezing cylinder. Install the
front scraper blade over the front holding pin. Slide the
beater assembly the rest of the way into the freezing
cylinder.
Figure 9
Make sure the beater assembly is in position over the
drive shaft. Turn the beater slightly to be certain that
the beater is properly seated. When in position, the
beater will not protrude beyond the front of the freezing
cylinder.
Step 6
Before assembling the freezer door, check the
following for any nicks, cracks, or signs of wear:
front bearing, door gasket, draw valve, o- rings, and all
sides of the door assembly, including the inside of the
draw valve bore. Replace any damaged parts.
Step 7
Slide the two o- rings into the grooves on the draw
valve and lubricate them with Taylor Lube.
Figure 10
