Taylor 358, Руководство по обслуживанию

Страница: 30 / 60

26
General Service Models 358 & 359
Pulley Alignment
______________________________
Pulley alignment is to be performed only after proper
rear bearing unit alignment has been established.
1. Loosen the direct drive pulley.
2. Use a straight, flat bar and hold it firmly against
the large rear bearing unit pulley.
Figure 13
3. Adjust the direct drive pulley until it is flush with
the motor pulley.
Figure 14
4. Tighten the direct drive pulley set screw.
If the belt does not fit within the groove of the
motor pulley, re-adjust the direct drive pulley
until a proper fit is achieved.
Rear Shell Bearing
______________________________
Prior to installation, place silicone silastic around the
outer diameter of this area.
Figure 15
Beater Shaft Removal
______________________________
Beater Shaft Retriever Assembly
(Part No. X26533)
The beater shaft retriever is a device used to
remove a drive shaft from the drive coupling.
Figure 16
https://appliancetechmanuals.com