16
800-628-5188
Rev: 10.13.21
Taylor Made
®
Manual Bimini
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004206
Fig.42
secondary bow
assembly
primary
bow
assembly
rear
support
tube
rear
front
4.
Install the protective boot
(Fig.43A)
over the collapsed
frames and canopy with the boot’s stern light opening
centered over the stern light mounting holes, then zip the
boot closed.
Fig.43
A
3.
Carefully guide the canopy and frame assembly towards
the rear of the pontoon until all of the frames collapse
together onto the primary bow assembly
(Fig.42)
.
If a fully collapsed bimini top is desired, where the
collapsed frame and canopy rests flat on the rear of
the pontoon:
1.
Make sure the bimini top is in the radar position and the
protective boot is installed
(Fig.43)
.
2.
Remove the quick-release ring
(Fig.44A)
pins from each
rear support tube H-bracket
(Fig.44B)
.
Fig.44
3.
Lift the rear support tubes out of the H-brackets, then
reinsert the quick-release ring pins
(Fig.45A)
into the tubes’
pivot hole.
A
B
rear support tube
Fig.45
A
