12
800-628-5188
Rev: 10.13.21
Taylor Made
®
Manual Bimini
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004206
3.
Install adjustable front support tube H-brackets:
A.
Remove the quick-release ring pins
(Fig.29A)
from the
H-brackets
(Fig.29B)
. Set the quick-release ring pins aside
for later use.
B.
Position the secondary bow assemblies towards the
rear so the attached adjustable front support tubes are
safely out of the way for the installation of the H-brackets.
Fig.27
C.
Place the two adjustable front support tube H-brackets
(Fig.30A)
at the previously marked locations (step 1),
aligning the center of the pivot pin hole with the marked
measurement
(Fig.30)
.
D.
Secure each H-bracket to the fence railing with two
Phillips head self-drilling screws
(Fig.30B)
.
E.
Reposition the secondary bow assembly towards the
front until the attached adjustable front support tubes
(Fig.31A)
are over the H-brackets
(Fig.31B)
. Secure the
adjustable front support tubes to the H-brackets with
the previously removed (step A) quick-release ring
pins
(Fig.31C)
.
Fig.28
2.
For each adjustable front support tube, press in on its
adjusting snap button
(Fig.28A)
and extend the inner tube
downward to the last height adjustment hole
(Fig.28B)
. Make
sure the adjusting snap button pops out of the last height
adjustment hole to secure the full height of the adjustable
front support tube.
Fig.29
center
mounting
H-bracket
front
38”
left secondary bow
assembly
left
adjustable
front
support tube
fence
railing
A
fully retracted
position
fully extended
position
B
B
A
A
marked measurement
B
pivot pin
hole
fence
railing
Fig.30
